Description
Main Control Chip】The main control board uses 32-bit ARM-level Cortex-M4 series STM32H723ZE chip with a frequency of up to 550MHz and the flash is 1MB.
【Support 60V Input】Supports up to 8 3D printer motherboards 
with a maximum 60V stepper motor. The motor drive power supply supports up to 60V input (only for the motor drive power supply).
【6 Controllable Fans】Up to 6 controllable fans, two normally open fans, and both support power supply voltage, 12V, 5V options.
【Update Firmware: Klipper/Marlin/RRF】Supports firmware update via DFU mode. This is where the firmware is sent to the board directly from the PC and does not require a bootloader however this method is not recommended for novice users as discussed later in this document.
【Level conversion IC】Supports proximity sensor, jumper optional pull-up resistor, supports more models, supports BL Touch.
Jaspal Singh (verified owner) –
The STM32H723ZE is a high-performance microcontroller from the STM32H7 series by STMicroelectronics. It is based on the Arm Cortex-M7 core, which operates at up to 550 MHz. Provided information on this website that the chip is (168MHz ) is incorrect.. Requesting the website content creater to fix it.